When I inspected the motor controller water cooling lines at the conyroller inlet and outlet, I found they were dry, so no cooling at all!
Today I rerouted the entire motor controller cooling circuit, adding a reservoir just higher than the controller.
While I was in there in also changed my home made vacuum reservoir to a more compact and lightweight commercial unit.
Hi, where did you buy your original cooling tubes/setup for the Soliton, I have a soliton Jr, but I think the fittings are the same and I want to build something soon. thanks - josh (josh at coolbluewater dot org)
ReplyDeleteSorry I didn't answer this sooner... I just noticed.
ReplyDeleteThe elbows were purchased from Amazon:
Bikers Choice Oil Line Fitting 90 DEG Elbow Chrome https://www.amazon.com/dp/B000WKNKZK/ref=cm_sw_r_other_awd_0MnKwbD837F03